Intercooler piping for the Mahindra Roxor

RX Intercooler Kit (for Mahindra Roxor)

Genuine Ford EcoBoost Intake Manifold Gasket Kit (6 individual gaskets)

Genuine Ford EcoBoost Intake Manifold Gasket Kit (6 individual gaskets)

Snow Performance Water Methanol Kit for Mahindra Roxor (DS)

Custom Spec'd Water Meth kit for Mahindra Roxor

$950.00
In stock
SKU
SNO-210-4523-40400-40040

Upgrade Your Adventure with this custom spec'd Snow Performance Water Methanol kit for the Mahindra Roxor. This kit will add power while decreasing your air temps by up to 150 degrees! The all-new Snow Performance Stage 2 Boost Cooler® water-methanol injection system comes fully revamped in 2015 and uses a progressive gauge style controller that proportionally injects more or less according to boost pressure. Start and full points are adjustable for engagement and deliver a curve to match what the engine requires. Proportionally injecting according to boost pressure gives an accurate delivery of water-methanol and allows cooling and performance improvements over a wide range for improved drivability. Taking it one step further, Stage 2 has the ability to progressively command 2 Hyper-Sonic™ Nozzles independently of one another. This sophisticated dual stage injection management yields the highest increases in HP and cooling along all stages of the engine allowing you to greatly increase the boost & timing of your vehicle safely. Proven to deliver horsepower and cool inlet temps up to 150 degrees!

The VC-50 comes with a dual 7 color OLED screen and displays boost, percentage of injection, low level, and secondary nozzle activation directly on the screen. Complete with our industry-leading Snow Performance 300 PSI UHO pump and Hypersonic Nozzles, the Stage 2 promises to deliver the best atomization and power available for your boosted vehicle.

Kit Includes:

  • 300 PSI UHO (Ultra High Output) Pump
  • 2.5 Gallon Tank!
  • All Tubing Necessary for Installation
    10’ ¼ Inch High Temp Nylon Tubing
    18” High-pressure Boost Line
    3’ (Black) Wire Loom
  • VC-50 Controller
  • Pigtail Harness
  • 2 1/16 Gauge Pod
  • Level Switch Upgrade
  • 1 Nozzle Holder/Check Valve Combo
  • 3 Hyper-Sonic™ Nozzles (175, 375, 625 ml/min) For Applications up to 1,000 HP (for custom nozzle selection give us a call at 719-633-3811)
  • Required Hardware Needed For Installation
  • Quick Connect Fittings Included
  • Snow Performance Running S Decal
  • Comprehensive Instructions to Install on Any Forced Induction Vehicle
  • Snow Performance 1-Year Warranty

 

Prop 65WARNING: Cancer & Reproductive Harm - P65Warnings.ca.gov

We found other products you might like!